![]() ![]() Change your timezone and DST to match where you are.Uncheck "Use DNSMasq for DNS", "DHCP-Authoritative", "Forced DNS Redirection".Set the Gateway IP to your primary router's IP address.Enter a router Local IP address in the same subnet range as your primary router, outside the dhcp pool (e.g.Go to Setup -> Basic Setup and change WAN Connection Type to Disabled.Set a username and password, if not asked for this, do a proper reset.Set your browser to 192.168.1.1 and open the dd-wrt GUI.Set your computer to a static IP address e.g.Connect a cable from your computer to the LAN port on your router.See Where do I download firmware?, new build threads.Download a recommended build: The Router Database does NOT have recommended builds.Most primary routers will be at 192.168.1.1, so use something else not in the DHCP range. What this means is, if the primary router has an IP of .X, you need to set the CB router to an IP of .Z. You don't need to worry about the primary router as long as you set your CB to the SAME subnet. The router you are configuring is the Client Bridge (CB) router. The router that you are trying to connect to is the primary router. In this case, use Repeater Bridge - which provides a bridge to both wired clients and another AP extended for more potential wireless clients, all of which will be bridged through the Repeater Bridge device. MIMO radios, Client Bridge may not exist in the list of wireless modes. If CB will not work on your hardware, try Client Mode instead.Īlso note that on newer hardware and dd-wrt versions, e.g. For example, the 2.4GHz radio can a CB while the 5GHz is an AP, or vice versa.Ĭlient Bridge with dd-wrt SP1 won't work. The other radio(s) would normally be set as AP. If using a multi-band router, do not set more than one band to CB.All devices connections, besides the primary router, MUST be wired to the CB router. CB is a wireless connection ( NOT wired) between two routers only. See Linking Routers for a description of each of the modes.Ĭlient Bridge (CB) extends a wired LAN using a wireless connection, as opposed to an Access Point that extends the Wireless LAN (WLAN) using a wired connection. It will cause connection problems for more than a single client. It is by design a hack and not a true transparent bridge like WDS. Client Bridge will never be as stable as any of those modes. Only use this or Repeater Bridge mode if all of the others are unsuitable: WDS, Client, Repeater, or AP. Wiki Path: DD-WRT Wiki Main / Tutorials / Linking Routers / Client Bridged ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |